I got an Ender 3v2 from a buddy of mine! He says it doesn’t work… But if I can fix it I can have it!
First print. I see what he means…
Lets get this thing level. Printing a whole sheet lets me adjust as it prints, and make sure adhesion is good.
Lets replace that nozzle… It’s looking a little ground down.
While we’re at it, we should replace the stock feeding tube and extruder as well!
A little better leveling sheet layer!
Definitely usable!
Lets try that print again… Not really looking so hot. Or, looking a lot of hot actually, it looks melted!
Adding in a figure with supports, but extreeeeme stringing.
I couldn’t even get the supports off without breaking the figure. They were fused!
Some adjustments were made in the splicer and I wanted to see just what was going wrong. So, first benchy!
Made more adjustments to feeding and retraction from the extruder, as well as temp.
Take a Dick Pick, and one of my spare Fucks to give!
Well… THAT went bad.
Viking Mug
This print is my favorite but it took 3 days!!!
Final product, 3 days of printing, but it is really cool! It holds a can like a coozie!
